The G6145SCU is one of the plainer G 6000 machines and a common sight in rental and secondary kitchens. Slow drainage complaints on this model are often traceable to the air gap or high loop at the sink rather than to the dishwasher at all, and that is worth establishing before anyone dismantles a pump. […]

The G6365SCVi is a mid-range G 6000 integrated machine and one of the most common Miele dishwashers still in daily service in American kitchens. Its door damper is a part owners notice only once it goes: a door that used to settle gently starts dropping, which then stresses the hinges and the custom panel fixings. […]

Some G6625SCU configurations shipped with Miele@home connectivity, and a fair share of the calls we take on it are not repairs at all – the machine has simply lost its pairing after the household changed routers or bands. The dishwasher continues to work normally in that state. It is worth separating from a real problem […]

The G6665SCVi is the handleless configuration of Miele’s G 6000 integrated range, designed for kitchens where a door handle would break the run of cabinetry. That makes the Knock2open sensor a functional part rather than a luxury here – without a handle there is nothing to pull. It can still be opened from the machine’s […]

Tall-tub G 6000 machines such as the G6785SCVi were pitched at households that wash large platters and stock pots, and they earn their keep there. The compromise is that the extra height gives the door a longer seal run and more leverage on the hinges, so alignment matters more than it does on a standard […]

The G6875SCVi is close to the top of the G 6000 integrated range and carries the interior lighting that owners of tall tubs appreciate most, since the upper reaches of an XXL cavity are genuinely dark. That LED strip tends to fail progressively from one end rather than all at once, which is a helpful […]

The K2O suffix on the G6987SCVi marks it as the Knock2open configuration, and the detail that matters in service is that the sensor is tuned to the panel it was installed behind. Fit a substantially heavier or thicker cabinet front later and the knock response changes, even though nothing in the machine has failed. We […]

The G7106SCU is the accessible built-under machine in Miele’s current G 7000 range, without the AutoDos PowerDisk hardware of the higher models. That makes it a simpler proposition to service – there is no dosing unit in the diagnostic path – and it is one of the reasons these are a sensible choice in kitchens […]

Fully-integrated G 7000 machines like the G7156SCVi are specified into new kitchens in large numbers, and the installation issue that follows them is clearance. AutoOpen needs a few centimetres of free travel at the top of the door, and a worktop with a deep front lip will not give it. When a nearly-new machine of […]

AutoDos on the G7366SCVi meters detergent automatically from a PowerDisk cartridge in the door, releasing it at the right point in each program rather than all at once. The dosing unit is the part that distinguishes this model in service, and most of its problems are seating rather than mechanical: a disk that has not […]